Previous view
12
RESETTING
■ Resetting
The LCD may occasionally display erroneous informa-
tion (e.g. when fi rst applying power). This may be caused
externally by static electricity or by other factors.
If this problem occurs, turn power OFF. After waiting a
few seconds, turn power ON again. If the problem per-
sists, perform either or both of procedures below.
D Partial reset
If you want to reset the operating conditions (VFO fre-
quency, VFO settings, and Set modes contents) without
clearing the memory contents, do a partial reset.
q Hold down [ ] for 1 second to turn OFF the power.
w While holding down [VFO/MR/CALL], hold down [ ]
for 1 second to turn ON the power.
D All reset
The all reset clears all programming and returns all set-
tings to their factory defaults.
q Hold down [ ] for 1 second to turn OFF the power.
w While holding down [MONI] and [VFO/MR/CALL],
hold down [ ] for 1 second to turn ON the power.
• "CLEAR" appears when the transceiver is totally reset.
CAUTION: The all reset returns all programmed con-
tents to their default settings.
46