Using the Remote Control
This section explains how to operate the camera using the optional DR-3 remote
control unit.
Important
• Operate the remote control unit by pointing to the remote control receiver
Note
located on the front.
• For instructions on replacing the batteries and maintaining the remote control
Note
unit, refer to the accompanying manual.
• Some procedures differ when performed on the remote control unit and on
the camera itself. Follow the instructions below to use the remote control
unit.
Shooting
The remote control unit can be used to operate the camera. It is particularly convenient
when the camera is set up at a remote location or is in a fixed position.
q Set the mode dial to shooting mode [
[
].
w Decide the composition of the picture
and press the RELEASE button.
In
(still picture) mode
The self-timer LED will light and recording will
start about 2 seconds later.
In
(Text) mode
Press the RELEASE button to start recording
immediately.
In
(Quick shooting) mode
Shots will be taken continuously while the
RELEASE button is pressed. Shooting will stop
when the RELEASE button is released and the
shots will be recorded.
In
Motion Picture mode
Press the RELEASE button to start recording.
Press the RELEASE button again to stop
recording.
]
ERASE
EV
MULTI
5
RELEASE
FWD
PROGRAM
ENTER
REV
101