Ricoh RDC-6000 Operation Manual page 54

q Set the Mode dial to [
w Press the Flash button to select the flash
mode ( •
The flash mode will change each time the Flash
mode button is pressed.
The flash mode will be displayed on the LCD
panel and LCD monitor. In the Auto Flash mode,
however, the
the LCD monitor. This mark will not be displayed
on the LCD panel.
e Press the release button to take the photograph.
When the flash fires, the flash LED (red) will light when the release button is
pressed lightly.
When the flash is being recharged, the flash LED will flash and the display will
disappear from the LCD monitor. Photographs cannot be taken at this time.
• When using the flash for nearby subjects (approx. 0.3m (12 inches) or
Important
Note
less), the light from the flash may appear to be reddish in some cases.
This also causes overexposure so the subject may appear whitish in the
photograph. At such times, select the Flash off mode.
• The shutter speed will automatically become slower in dark places. In
such cases, either grip the camera firmly or mount the camera on a tripod
to prevent camera shake.
• The flash does not fire in the Text mode, Quick shooting or Motion Picture
Note
mode.
• The flash does not fire in the White Balance mode.
• Use the keep Setting Mode to hold the Flash mode setting.
"Keep Settings".
• The Redeye Reduction mode can be used to reduce the occurrence of the
redeye phenomenon.
52
].
• • Blink).
mark will be displayed only on
Page 64 "Redeye Reduction Mode".
1600 N
10:12 2000/05/15
Page 94
17