Shooting Using The Remote Control Unit - Ricoh WG-6 Operating Manual

Memo ---------------------------------------------------------------------------------------------------------
• The focus setting and exposure value are fixed during continuous shooting.
• The maximum number of images that can be taken continuously varies depending on the [Recorded
Pixels] setting in the A menu.
• The continuous shooting setting is reset when the camera is turned off and on again.
• If you release z early for [M-Cont], the number of saved images may not reach 16 or 25.
• The images taken with [M-Cont] or [S-Cont] are displayed in 16 or 25 thumbnails in the single image
display of C mode. Press 4 (T) to display an image in the single image display, and cd to
display the previous or next image.
3

Shooting Using the Remote Control Unit

You can perform shooting using the optional remote control unit.
1
Press w (a) in the shooting mode.
The [Drive Mode] screen appears.
2
Use ab to select a setting.
0-sec Remote Control
3-sec Remote Control
3
Press e.
The shooting screen reappears.
4
Point the remote control unit towards the remote control
receiver of the camera, and press the shutter release button.
Memo ---------------------------------------------------------------------------------------------------------
• The maximum operating distance of the remote control unit is about 4 m from the front of the camera
and about 2 m from the rear of the camera.
58
Releases the shutter immediately after the shutter release button on the
remote control unit is pressed.
Releases the shutter about 3 seconds after the shutter release button on the
remote control unit is pressed.