Q-See QC40198 User Manual page 61

MAIN MENU
DHCP: You use this option to have the router the DVR is attached to assign an IP address for you. When you
enable the DHCP function, you cannot modify IP/Subnet mask /Gateway. These values are assigned by the
DHCP function in the router. If you have not enabled DHCP function, IP/Subnet mask/Gateway display is zero.
You need to disable DHCP function to view current IP information. When PPPoE is operating, you cannot
modify IP/Subnet mask /Gateway.
TCP port: Default value is 37777.
UDP port: Default value is 37778.
HTTP port: Default value is 80.
IP address: Here you can input a static IP address.
You will need to setup the network settings on the DVR to match the settings of the router that you attach the
DVR to. To get the router settings you would go to the run option on a computer attached to the same router as
the DVR and type cmd and hit OK to bring up a command prompt (Figure 5-10), then type ipconfig at the
prompt (RED arrow on Figure 5-10) to access the router settings. Write down the gateway and subnet mask
numbers (GREEN arrows on Figure 5-10) so you can copy them into the network settings on the DVR. Use the
MENU on the DVR to get to the system's NETWORK screen shown as Figure 5-9.
For the DVRs IP address you would enter the same first 3 sets of numbers as the gateway and select a fourth
set of numbers that is different then any other device attached to the same router. If the IP address of your
computer in the ipconfig (BLUE arrow in Figure 5-10) was a single or two digit number you should be ok with
any three digit number, if the computer IP address ends with a number in the 100s then you should go with a
200 number. Enter the same Gateway and Subnet as the green arrows in ipconfig.
Maximum connections: system supports up to 10 users. 0 means there is no connection limit.
Transfer mode: Here you can select the priority between fluency/video qualities.
LAN download: System can process the downloaded data first if you enable this function. The download speed
is 1.5X or 2.0X of the normal speed.
After completing all the setups please click save button, system goes back to the previous menu.
QC40198/QC40196 User Manual