Q-See QC40198 User Manual page 104

WEB OPERATION
Network
Network interface is shown in
Please refer to the following chart for detailed information.
Function
Select the network card first.
Dynamically get IP address. You can get the device IP from the router if
you enable this function.
Default value is 37777.
Default value is 80.
Default value is 37778.
Maximum Network users. The value ranges from 0 to 10.
O means no users can access current device.
PPPOE
Figure 7-44.
X462H 462H462H
Figure 7-44
Input the PPPoE user name and password you get from the
IPS (internet service provider) and enable PPPoE function.
Please save current setup and then reboot the device to
get the setup activated.
Device connects to the internet via PPPoE after reboot.
You can get the IP address in the WAN from the IP address
column.
Please note if you want to reboot the device please make
sure you have proper reboot right and there is no user
logged in.
QC40198/QC40196 User Manual