Q-See QC40198 User Manual page 110

WEB OPERATION
Please refer to the following chart for detailed information.
Parameter Function
Event
Type
Alarm in
Enable
Type
Period
Anti-dither
Normal
Out
Alarm
Latch
Alarm
upload
Record
Channel
Record
Latch
Email
Tour
PTZ
activation
Capture
Copy
Save
Refresh
Includes local alarm/network alarm.
Local alarm: Device detects alarm from input port.
Network: Device detects alarm from network.
Select corresponding alarm channel.
You need to put a checkmark here so that system can detect the
alarm signal.
There are two options: normal open and normal close. NO becomes
activated in low voltage, NC becomes activated in high voltage.
Alarm record function becomes activated in the specified periods.
There are six periods in one day. Put a checkmark to enable
corresponding period.
Select date. If you do not select, current setup applies to today only.
You can select all week column to apply to the whole week.
Click OK button, system goes back to alarm setup interface, please
click save button to exit.
System only memorizes one event during the anti-dither period. The
value ranges from 0 to 15s.
Enable alarm activation function. You need to select alarm output port
so that system can activate corresponding alarm device when alarm
occurs.
System can delay the alarm output for specified time after alarm ends.
The value ranges from 10 seconds to 300 seconds.
System can upload the alarm signal to the centre (Including alarm
centre.
System auto activates current channel to record once alarm occurs
(working with alarm activation function). Please note current device
shall be in alarm record period (Chapter 7.3.2.3 Schedule) and you
have enabled the schedule record function in chapter 7.3.3.3 Record.
System can delay the record for specified time after alarm ends. The
value ranges from 10s to 300s.
Put a checkmark to enable email function. System can send out email
to alert you when alarm occurs and ends.
Display the selected video in local monitor window.
Tour interval and tour mode are set in combo DVR local menu
(chapter 5.3.9 Display )
Here you can set PTZ movement when alarm occurs. Such as go to
preset x when there is an alarm.
The PTZ configuration events include preset, tour, and pattern.
You need to input capture channel number so that system can backup
snapshot file when alarm occurs.
This is a shortcut menu button. You can copy current channel setup to
one or more (all) channels.
You can click save button after you complete setup for one channel,
or you can complete the whole setup and then click save button.
Click this button to get device's latest configuration information.
QC40198/QC40196 User Manual