Troy-Bilt 1925 Owner's Manual page 6

ASSEMBLY
Your generator requires some assembHy and is ready for
use after it has been properHy serviced with the
recommended oiH and fuel
[f you have any probmerns with the assernbmy of your
generator, pmease carom the generator hempmine at
i=888=6 i i =6708°
Remove Generator From Carton
H. Setcarton on a rigid f iat s urface with"This SideUp"
arrows pointing upward.
2. Carefully open top flapsof shipping carton.
3. Cut down corners of carton from top to bottom and
Hay that side of carton down fiat.
4. Remove aHH packing mamriaL carton fiHHers, etc.
5. RoHH generator out of shipping carton.
A :ach
Handle
You wiHH need two H/2"or H 3 mm wrenches to attach the
handHe.
H. Attach handHe to right side of generator frame (viewing
unit from front), as shown in Figure H,with a 60 mm
capscrew, fiat washers, nyHonwashers, and Hocknut.
60ram Capscrew
i
Nut
' /Vqasher
i HandleBracket
{ Handle Pin
i
NOT_:: DO NOT overtighten. HandHe must be abHe to
move up and down freely.
2. Raise handHe and insert handHe pin to move generator.
0