Troubleshooting - Troy-Bilt 1925 Owner's Manual

TROU B LES H OOTi NG
Probmem
No AC output is avaHabme, but
generator is running.
GeneratoP Puns good at no-moad
but "bogs" down _' when loads are
connected.
GenePator will not staPt_ or staPts
and runs rough.
Generator shuts down during
operation.
Generator [acks power.
Cause
I.
One of the circuit breakersis
open.
Z Fault ingenerator.
3. Poor connectionor defective c ord
set.
4. Connected deviceisbad.
I. Short circuit ina connected load.
Z
Generator isoverloaded.
3. Shorted generatorcircuit.
I. lOAmp in°line fuse is blown.
2. Discharged battery.
3. Failed battery.
4. Low oil [eve[.
I. Out of gasoline.
2. Low oil level.
Load is too high.
Correction
Reset circuit breaker.
2. ContactAuthorized service facility.
3. Check and repair.
4. Connect another device that is in
good condition.
Disconnect shorted dectrical load.
2.
See "Don't
Overload Generator".
3. ContactAuthorized service facility.
Replace fuse.
2. Jump start generator
and/or
charge
battery.
3. Replace battery.
4. Fill crankcase to proper level or
place generator on level surface.
Fill fuel tank.
2. Fill crankcase to proper level or
place generator on level surface.
See "Don't Overload Generator".