Troy-Bilt 1925 Owner's Manual page 12

5ectbn 4: Opecatbn
[ 20 Vok AC, 20 Amp,
Duple×
Each dupiex recepgacie (Figure i 3) is protected against
overioad by a push-to-reset circuit breaker.
The maximum bad on each outlet is 20 Amps.The
maximum toga[ bad on both yellow wire outlets or both
biack wire outiets is 30 Amps.
[NOTE: Follow ali safety precautions when connecting any
extension cord or device to the generator.
RECEPTACLES
CAUTION
o NEVER attempt to power a device requiring more
amperage than generator or recepgacie can suppiy.
o DO NOT overioad the generator. See "Don't Overioad
Generator".
Use each recepgacie to operate [20VoHtAQ singie-phase,
60 Hz electrka[ loads requiring up to 2,400 watts (2A kW)
at 20 Amps of current. Use cord sets that are rated for
[ 25 Voit AC [oads at 20 Amps (or greater).
[ 201240 VoUt AC, 30 Amp, Locking
Receptacle
Use a NEMA L14-30 piug with this receptacHe. Connect a
4-wire cord set rated for 250Voit AC [oads at 30Amps (or
greater) (Figure [4).You can use the same 4-wire cord if
you plan to run a i20Voit load.
[ 2 Volt DC, [ 0 Amp Receptacle
This receptacle allows you to recharge a [2Vok
automotive or utility styie storage battery with the battery
charge cabies provided (Figure 12).
This receptacle can not recharge 6Voit batteries and can
not be used to crank an engine having a discharged battery.
See the section "Charging a Battery" (page [ 0) before
attempting to recharge a battery.
4oWire Cord Set
/
(Neutral)
Y (Hot) | X (Hot)
NEMA LI 4-30 /-7L7 Ground (Green)
This recepgacie powers i20/240VoitAC, 60 Hz, single
phase loads requiring up to 7,200 watts of power (7.2 kW)
at 30 Amps for 120Volts or 240Volts.The outlet is
protected by a rocker switch circuit breaker.