Troy-Bilt 1925 Owner's Manual page 4

Section 1: Safety Rules
WARNING
WHEN ADJUSTING OR MAKING REPAiRSTOYOUR
GENERATOR
, Disconnect the spark ptug wh_efrom the spark plug and place
the wire where it cannot contact spark pIu&
WHENTESTING FOR ENGINE SPARK
" Use approved spark plug tester:
DO NOT check for spark with spark plug removed,
WARNING
DO NOT touch hot surfaces.
. Allow equipment to cool before touching.
. The generator must be at least S feet from structures having
combustible walls and/or other combustible materials_
Keep at least 3 feet of clearance on all sides of generator for
adequate cooling, maintenance and servicing.
In the State of California a spark attester is required by law
(Section 4442 of the California Public Resources Code). Other
states may have similar laws. Federal laws apply on federal
lands_ [f you equip the muffler with a spark arresten it must be
maintained in effective working order.
CAUTION
DO NOT tamper with governed spee& Generator supplies
correct rated frequency and voltage when running at governed
speed.
DO NOT modify generator in any way.
See "Don't Overload Generator".
Start generator and let engine stabilize before connecting
electrical Ioads_
Connect electrical loads in OFF posidon_ then turn ON for
operatiom
Turn electrical loads OFF and disconnect from generator
before stopping generator_
Use generator only for intended uses.
If you have questions about intended use, ask dealer or call
1-888-61 1-6708.
Operate generator only on level surfaces_
DO NOT expose generator to excessive moisture, dust, dirt,
or corrosive vapors.
DO NOT insert any objects through cooling slots,
If connected devices overheat, turn them off and disconnect
them from generator:
Shut off generator if:
-electrical
output is lost;
-equipment sparks, smokes, or" emits flames;
-unit vibrates excessively.