Using The Software - Extron electronics VGA MATRIX SWITCHERS MVX PLUS 128 User Manual

Using the software

Many items found in the Matrix Switcher+ Control Program are also accessible via
front panel controls (see chapter 3, Operation) and under SIS control (see chapter 4,
Programmer's Guide). The Matrix Switcher+ Help Program provides information on
settings and on how to use the control program itself.
1. To run the Matrix Switcher+ Control Program, double-click on the Matrix
Switcher+ Control Program icon (shown at right) in the Extron Electronics
group or folder.
The Comm Port Selection window (fi gure 5-1) appears.
Figure 5-1 — Comm port selection window
2. Choose either the comm port that is connected to the MVX Plus 128 switcher's
RS-232/RS-422 port, IP [LAN], or Emulate.
If you selected a comm port, check the baud rate displayed in the comm
port selection window. If you need to change the baud rate, click on the
Baud button and double-click on the desired baud rate.
Available rates are 9600, 19200, 38400, and 115200. The default is 9600.
Click OK and proceed to step 4.
If you selected IP [LAN], click OK and proceed to step 3.
If you selected Emulate, click OK and see Using emulation mode on
page 5-19.
MVX Plus 128 VGA Matrix Switchers • Matrix Software
5-3