Table of Contents
Advertisement
Button Labels
Page B-9 provides strips of blank button labels. If desired, photocopy them or cut
them out of the manual, write button information in each button area as desired,
and put them in the switcher's input or output buttons' windows. You can also
create labels using the Button-Label Generator software (see chapter 5, Matrix
Software).
Installing labels in the matrix switcher's buttons
Use the following procedure to install new labels in the matrix switcher's front
panel buttons.
1.
Make new labels using either the blanks on page B-9
or the Button-Label Generator software. Cut them
out.
2.
Remove the button from the switcher by grasping
the button fi rmly and pulling it away from the front
panel.
N There are different button models available. Your
3.
Use a small screwdriver or Extron Tweeker to gently
lever the button cap off of the white backing plate.
4.
Insert a button label into the cap and gently but
fi rmly press the cap onto the white backing plate.
5.
Press the button into place in the matrix switcher
MVX Plus 128 VGA Matrix Switchers • Specifi cations, Part Numbers, Accessories
buttons may appear different.
Use notch to
remove button.
T E
X T
Separate two
piece button here.
B-7
Advertisement
Table of Contents
