Table of Contents
Advertisement
Front Panel Operations
The following paragraphs detail the power-up process and then provide sample
procedures for creating ties, changing a confi guration, viewing confi gurations,
saving and recalling a preset, muting and unmuting outputs, viewing and adjusting
the audio level, viewing and adjusting the output volume, locking out the front
panel, performing one of several resets, toggling background illumination on and
off, and reading and setting the RS-232/RS-422 Remote port settings.
Power
Apply power by connecting the power cord to an AC source. The switcher
performs a self-test that fl ashes the front panel button indicators green, red, and
amber and then turns them off. An error-free power up self-test sequence leaves
all I/O and control buttons either unlit or showing background illumination. The
lit/unlit status RGBHV or Video button and the Audio button is the same as when
the switcher was powered off.
The current confi guration and all presets are saved in non-volatile memory. When
power is applied, the most recent confi guration is retrieved. The previous presets
remain intact.
If an error occurs during the self-test, the switcher locks up and does not operate.
If your switcher locks up on power-up, call the Extron S
Hotline.
Creating a confi guration
The current confi guration can be changed using the front panel buttons. Change
the current confi guration as follows:
1.
Press the Esc button to clear any input button indicators, output button
indicators, or control button indicators that may be lit.
2.
Select to confi gure video, audio, or both by pressing the RGBHV button
and/or Audio button.
3.
Select the desired input and output(s) by pressing the input and output
buttons.
4.
Press and release the Enter button to accept the tie.
5.
Repeat steps 1 through 4 to create additional ties until the desired
confi guration is complete.
Input buttons and output buttons light or blink amber to indicate video
and audio ties, green to indicate video only ties, and red to indicate audio
only ties.
To indicate potential ties, output buttons blink the appropriate color
when an input is selected.
To indicate current ties, output buttons light steadily the appropriate
color when an input is selected.
To clear unwanted outputs, press and release the associated lit output
buttons. To indicate potential unties, output buttons blink the
appropriate color when an output is deselected but not untied from the
input.
MVX Plus 128 VGA Matrix Switchers • Operation
3
Sales & Technical Support
3-7
Advertisement
Table of Contents
