Mitsubishi LT-46149 Owner's Manual page 66

66 6. NetCommand IR Control
3, Press ENTER and the highlighted input label will start
flashing to indicate readiness for "learning."
4, While the Input text is flashing, press and hold the
key on the A/V receiver's remote control for the
input you wish to associate with the selected Input
label.
Z
When a check appears next to the input label,
release the remote control key.
• If the text stops flashing before the check mark
appears, repeat this step.
To erase the IR code just "learned," press CANCEL
while the name is highlighted.
On the TV's remote control, press I_ once. The
highlight will move automatically to the associ-
ated Assign input column (Assign Input1 through
Assign Input5).
Use A Y to highlight the device type connected to
the A/V receiver input just "learned." The Assign
input column contains a list of possible device
types.
In the example above, a DVD player is connected to
the A/V receiver input the TV knows as Input2.
The device type you select here will appear as an
icon in the TV's Input Selection menu. You can
assign each device type in the list only once.
8, Press EXIT if finished or repeat these steps for addi-
tional video sources connected to the A/V receiver.
NetComrnand IR Control: Device
Connected to an A/V Receiver
Use this setup to have NetCommand control a device
sending audio and video through the A/V receiver to the
TV via HDMI.
1, Set up NetCommand control of A/V receiver audio/
video switching via HDMI as described on the pre-
vious page.
Any Con- 1
nection Type
3_
4,
Z
Press EXIT to close any open menus and return to
normal TV viewing.
Press INPUT t o open the Input Selection menu.
Highlight the icon for the A/V receiver input you
wish to control.
The A/V receiver's remote control key for the input
must have been "learned" previously using "Setup
to Control Automatic Audio and Video Switching via
HDMI" on the previous page.
Press ENTER to switch the TV to the A/V receiver and
the A/V receiver to the device.
Open the Inputs > Learn menu.
Perform NetCommand "learning" for the device by
following the steps in "Initial NetCommand Setup
for Most Devices," page 57.