Mitsubishi LT-46149 Owner's Manual page 51

5. TV Menus 51
/nputs Menu
Blu. Ray),CableAudio,B°X'DVDDvR,Camc°rder'(DVD,GameDVD2,(Game, cD/
PS, Xbox, Wii), MP3 Player, PC,
Satellite, VCR, AVR
On/Off (ANT 1 and ANT 2 only)
Delete (deactivated HDMI only)
HDMIC°ntr°lenabled°nly whencontrolHDMlOn'lnputsC°ntr°ldeviceS;is set to > NetC°mmand°perateSon) Off (CEC-
Lets you assign or change names of inputs appearing in the
Input Selection menu.
Press 4 1!_ to move between inputs.
Press A V to select a name.
Lets you tum Ant-1 and Ant-2 On/Off (to display/hide in Input
Selection menu).
• Lets you delete unused HDMI inputs from the Input Selection
menu.
If you change the name of an input after performing NetCom-
mand "learning," the IR codes you "learned" are erased.
General Notes
When you change an input name in the Name menu and then exit the Name menu:
The name is changed
The icon in the Input Selection menu is changed
Audio and video settings are changed to the defaults for the new device type.
All previous NetCommand "learning" for the input is erased.
Notes for HDMI devices
Disconnecting an HDMI device: When you disconnect an HDMI device, the icon remains in the input Selection
menu until you remove it. Select Delete in the Inputs > Name menu to remove an unwanted icon for an HDMI input.
• NetCommand for HDMI and CEC-Enabled Devices: If CEC conflicts occur, turn off CEC signals in one of
these ways: a) Turn off all NetCommand for HDMI signals from the TV (Inputs > NetCommand HDM! Control
menu), b) Turn off NetCommand HDMI signals for specific devices (Inputs > Name menu), or c) Turn off each
device's internal CEC capability. See Appendix E for the TV's NetCommand for HDMI Control or, to turn on/off
a specific device's response to CEC signals, see the device's owner's manual.
• Names of CEC=enabled devices: CEC-enabled devices send their own predefined name to the TV. You
cannot change the name of a CEC-enabled device; applies only when Inputs > NetCommand HDMI Control
is set to On.
Lets you put frequently used icons at the start of the Input Selection menu.
1. Press A V _ I_ to highlight the icon to move.
2. Press ENTER to confirm the selection.
3. Press A V _ I_ to drag the icon to the desired position.
4. Press ENTER to set the new position.
Sets up or changes NetCommand IR control of the current viewing device.
See detailed instructions in chapter 6, "NetCommand IR Control."
Sets up NetCommand IR control of an A/V receiver.
See detailed instructions in chapter 6, "NetCommand IR Control," starting on page 61.
_, . ...... Guide
Guide, Devices, Zip
Code
__. On, Off
NetCommand
HDM|Control
See instructions on page 78 for the TV Guide Daily system.
Select On or Off to enable or disable the TV's control of CEC-enabled
devices. See Appendix E for details.