Netcommand Ir Control - Mitsubishi LT-46149 Owner's Manual

6. NetCommand IR Control 57
To perform this procedure, you need:
• The remote controls for both the TV and the
device you want to control.
The IR emitter cable supplied with the TV.
3_
To set up an A/V receiver, see "Setting Up
NetCommand Control of an AN Receiver," page
61.
Connect and position the IR emitters for the
devices you wish to control. See "In Emitter Place-
ment" on the opposite page.
Set the TV's remote control slide switch to the TM
position and power on the TV if needed.
Open the NetCommand Learn screen in one of two
ways:
If working from the Auto Input Sensing screen
for the device, highlight the Learn icon and
press ENTER to open the Learn screen for the
device.
If performing NetCommand setup at any time
after the device has been recognized through
Auto Input Sensing:
a. Press INPUT t o open the Input Selection
menu.
b. Highlight the desired input icon and press
ENTER to switch to that input.
c. Press MENU, highlight Inputs, and highlight
Learn to open the Inputs > Learn screen
for the device.
4_
G_
Z
The first function highlighted in the Learn screen
is always Power On. Aim the TV's remote control
at the TV and press ENTER to begin learning for that
function.
When the Power On text starts flashing, aim the
device's remote control at the TV and press and
hold the POWER key until a check mark appears next
to Power On.
If the text stops flashing before the check mark
appears, repeat the previous step.
To remove the key from NetCommand control,
press the CANCEL key while the key name is
highlighted.
Press the A V _ 1_keys on the TV's remote control
to highlight other keys on the list. Repeat steps
4 and 5 for each additional function you wish to
control through NetCommand.
If the device's remote control has keys that are not
in the list, you can associate up to any four keys
with the F1through F4keys. Perform NetCommand
setup for the Fkeys the same way you did for the
named keys. For example, you can:
Assign your DVD player's CHAPTER SKIP FORWARD and
CHAPTER SKIP BACK keys to F1and F2.
A_to Input Sensing
From the Auto Input Sensing screen, highlight the Learn
icon and press ENTER to open the NetCommand Learn
screen.
Inputs > Learn screen
am
"Learn" your A/V receiver's DSP options for the
current device.
If the device has a separate POWER OFF key, press A
V _11 I_ on the TV's remote to highlight Power Off.
Repeat the earlier steps to "learn" the POWER OFF key.
if the device has no POWER OFF key, skip this step.
Press EXIT to finish NetCommand "learning" for the
current device.
3_
Press INPUT t o open the Input Selection menu, high-
light the device's icon and press ENTER.
Open the Inputs menu and highlight the Learn icon.
When the Learn screen displays:
To add keys: Continue as described earlier
under "Initial NetCommand Setup for Most
Devices" on this page.
To delete keys: Highlight the name of the key
you wish to delete and press CANCEL on the TV's
remote control to clear the check mark.