Mitsubishi LT-46149 Owner's Manual page 63

6. NetCommand IR Control 63
Before You Begin
3_
Note:
Connect your A/V devices to the TV and connect
your A/V receiver to the audio outputs on the TV
and the DVD player. See chapter 3, "TV Connec-
tions," for suggestions. Important: To use Setup
1, you must connect the A/V receiver to the TV's
audio output; i.e., the TV's AVR AUDIO OUTPUT or
DIGITAL AUDIO OUTPUT jack.
Position NetCommand IR emitters as described in
"lR Emitter Placement," page 56.
Open the inputs > AV Receiver menu.
The terms Inputl-lnput5 used in the AV Re=
ceiver menu are arbitrary names used by the TV
to uniquely identify A/V receiver inputs.
Audio Switching Setup 1: Automatic A/V Receiver
Switching to the TV Audio lnpu t
Most devices are set up to use the TV's audio output like
the VCR in this example; analog audio from the device is
sent through the TV to the A/V receiver's TV audio input.
Use this setup for:
• Sources providing only analog stereo output,
such as a VCR.
Audio from ANT 1 and ANT 2
3,
4,
G_
Under Learn, highlight Input1.
In this example, the IR code for the A/V receiver's
TV Audio input will be "learned" as Input 1.
Press ENTER on the TV's remote control.
While the text Input1 is flashing, press and hold the
TV INPUT k ey on the A/V receiver's remote control.
When a check appears next to Input 1, release the
TV iNPUT k ey.
If the text stops flashing before the check mark
appears, repeat this step.
• To erase the IR code just "learned," press CANCEL
while the name is highlighted.
Press 1_once to highlight TV Audio (TV audio
output) in the Assign Input1 column. The triangular
marker is always next to the assigned sound source.
Press EXIT if finished or continue with setup for
another TV audio source.
Completed NetCommand setup described for
controlling A/V receiver switching to the A/V receiver's
audio input from the TV's AUDIO OUTPUT.