Mitsubishi LT-46149 Owner's Manual page 65

6. NetCommand IR Control 65
Setting Up NetCommand Contro! of an A/V Re
TV main
panel
Multiple video inputs on a single HDMI cable. You can
connect multiple video devices to an A/V receiver that
has an HDMI output. The optional audio connection
allows you to hear, through the A/V receiver, devices
connected to the TV only.
4, Power on the A/V receiver.
Set the TV's remote control slide switch to the TM
position and power on the TV if needed.
6_ When theAuto Input Sensing screen displays,
select device name AVR.
Setup to Control A/V Receiver Power and Volume
Perform the steps under "A/V Receiver Control: Power
and Volume," page 61.
Se t up to Con tro Switch in th e T V Au d 0 Utp u t
If you have used one of the optional audio connec-
tions to the TV's AVR AUDIO OUTPUT or DIGITAL AUDIO
OUTPUT jacks, set up NetCommand to control switching
to the TV audio input. Perform the steps under "Audio
Switching Setup 1: Automatic A/V Receiver Switching
to the TV Audio Input," page 63.
Setup to Control Automatic Audio
and Video Switching via HDM !
Follow these steps if you wish NetCommand to control
switching of A/V receiver video as well as audio inputs.
When this setup is complete, you can use the TV's
Input Selection menu to select a video device con-
nected to the A/V receiver. You can also perform addi-
tional NetCommand setup to control devices connected
to the A/V receiver.
1, Display the Inputs > AVReceiver menu.
Note: The labels Input1 through Input5 in the Learn
column are names used by the TV to uniquely
identify AN receiver inputs.
With the highlight in the Learn column, highlight
one of the input labels Input2 through Input5; it
is recommended you leave Input1 reserved for TV
Audio.