Mitsubishi LT-46149 Owner's Manual page 80

80 Appendices
Appendix D: TV Guide Daily, continued ..............................................................................
Procedure
1, While in the Guide Listings, press MENU. T his dis-
plays the Setup Screen.
Highlight "Change channel display" and press
ENTER. The channel editor screen will appear.
3. Use 4 _" to highlight the desired row setting to be
changed.
• To change channel position (Position Number
highlighted), press A V to move the position or
enter a new channel position number. When
correct, press _ _ to move the highlight to
another position on the grid to save changes.
To change channel display status (status tile
highlighted; next to position number), repeat-
edly press ENTER to cycle through choices (on,
auto, off). When correct, press 41 I_ to move
the highlight to another position on the grid to
save changes.
To change tune channel number* (Channel
Tune Number highlighted; far right), enter
desired number with remote control number
keys (=/CANCEL key for digital sub-channel
separator). When correct, press 4 _ to move
highlight to another position on the grid to save
changes.
*Note: If you receive both analog and digital versions
of the same channel, do not change the tune channel
number of the digital channel to match the analog
station, as this may hinder the ability of the Guide to
receive data. Instead, locate the digital station in the
channel editor and, if necessary, change the channel
row position to a location you prefer.
1. When I enter the Guide I see a Setup Progress You have not yet received all of the program listings (it may take
screen, up to 24 hours to receive a full grid of listings).
2. Listings reads "Listings Pending." The Guide has not yet completed initial setup, changes you made
have not completed, or the Guide is setup incorrectly. Verify that
your TV is properly connected to the input source. Then, verify
that the ZIP code and input source (entered during initial setup of
Guide) are correct. See "Setting Up TV Guide Daily," page 78 for
more information.
3. Tiles in Listings read "No Listing" or "Title The Guide has not received updated show information or no infor-
Unavailable." mation was available the last time the Guide received an update,
update did not occur, or there was a power failure. Make sure you
turn the TV off when not in use to allow for updates. In the case of
a power failure, it may take up to 24 hours to update listings.
4. Tiles in Listings read "Turned Off." The channel you were watching before entering the Guide is
turned OFF in the grid. Use the channel editor to change the
channel setting to ON (see previous page, "Modify Guide Setup").
5. There are repeated or missing time slots in the The Guide is close to the time that a Daylight Savings time adjust-
Listings. ment is needed. The Guide automatically adjusts accordingly
when the local time is 2:00 a.m. to account for the affected hour of
programming. Once the adjustment is made, the Listings should
return to normal within 24 hours.
6. My channel lineup is incorrect or I see a An incorrect lineup for your area is selected in the Guide setup.
channel lineup screen when I enter the Guide. Select the correct channel lineup for your area (see previous page,
"Modify Guide Setup").
7. My TV is tuned to a different channel than the The Guide changes the channel to receive updates and does not
one I was watching the last time the TV was change the channel back until the update is complete. If the TV
turned off. is turned on before the update is complete, the channel will not
change back automatically.