Mitsubishi LT-46149 Owner's Manual page 9

1. Television Overview 9
Personal Computer," page 18, and Appendix B, "Specifi-
cations," page 69.
These inputs are HDCP (High-Bandwidth Digital Copy
Protection) compliant.
These inputs are Simplay/-/z7 certified for proper interop-
erability with other products certified by SimplayT'h
sound receiver or stereo system. Select AV Receiver
when the Auto Output Sensing screen displays.
Digital audio from digital channels and HDMI devices is
converted to analog audio by the TV.
10. SUBWOOFER OUTPUT
Connect a powered subwoofer to the SUBWOOFER
OUTPUT jack to complement Sound Projector speaker
effects. Select Subwoofer when the Auto Output
Sensing screen displays.
5. Composite Video (INPUT 1, INPUT 3)
Use the VIDEO jacks to connect a VCR, Super VHS (S-VHS)
VCR, DVD player, standard satellite receiver, or other A/V
device to the TV. Use the adjacent AUDIO R and L inputs
for INPUT 1 or INPUT 3 if you wish to send audio to the TV.
Note that the INPUT 3 composite video jack is automati-
cally disabled when you connect to S-VIDEO.
6. AUDIO L and R (INPUT 3)
Analog stereo inputs shared by INPUT 3 composite
video and S=VIDEO.
7. DVVPC INPUT AUDIO
Use the DVI/PC INPUT AUDIO jack when connecting
a DVI device to one of the TV's HDMI inputs using a
DVI-to-HDMI cable. These jacks allow you to send left
and right analog audio from your computer or other DVI
device to the TV.
8. S-VIDEO (INPUT 3)
Connect an S-Video device to this input. Use the INPUT
3 AUDIO R and L jacks (item 6) to send audio to the TV.
9. AVR AUDIO OUTPUT
A/V Receiver. Use the L and R jacks to send analog
audio of the current program to an analog A/V surround
11. DIGITAL AUDIO OUTPUT
This output sends Dolby Digital or PCM digital audio to
your digital A/V surround sound receiver. Analog audio
from analog channels and devices is converted by the TV
to PCM digital audio. If you have a digital A/V receiver,
in most cases this is the only audio connection needed
between the TV and your A/V receiver.
12. IR NetCommand Output/External
Controller Input
IR emitters connected to this jack are used by the TV's
NetCommand system to send control signals to external
IR remote-controlled devices such as cable boxes, VCRs,
DVD players, satellite receivers and audio receivers.
When NetCommand is not in use, this jack can be switched
to receive wired JRcontrol signals from external system
controllers. To switch this jack to an input, connect the
external controller's IR output to this jack, then:
1. Press MENU t o display the TV menu.
2. Enter the number sequence 2, 4, 7, 0 to display the
Installer menu.
3. Highlight the WIRED IR selection and press ENTER to
change the setting from OFF to ON.
Note:
To revert to NetCommand control:
1. Disconnect the IR device.
2. Press MENU t o display the TV menu.
3. Enter the number sequence 2, 4, 7, 0 to display the
Installer menu.
4. Highlight the WIRED IR selection and press ENTER to
change the setting from ON to OFF.
When the WIRED IR option is set to ON (control
by an external device), the Low Power setting
for Energy Mode is unavailable.