Philips VRZ364AT Owner's Manual page 45

Multi-Channel Television Sound S ystem ( VRZ364 o nly)(€ont'd) 45
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •e • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •• •• • • • • • • • • • •• • •• • • • • •
To receive and record programsbroadcast in secondaudio,follow steps I - 6.To receive and record a pro-
gram broadcastin stereo, make one of the connections shown,then follow steps I - 6.
If you have a Stereo and a Monitor T_,
use a video cable to connect theVCR's
VIDEO OUT Jackto the TV'sVIDEO IN
Jack.Use audio cable F to connect the
VCR'sAUDIO OUT Jacks to the
Stereo'sAUDIO IN Jacks.
I
Press theVCR button, then press the MENU button.
_LECT • • CHOOSE I_/OK
J
•_, VCR SET UP
TUNER SET UP
INITIAL _¢T UP
_TO END PUSH EXff
OR, if you havea single-speaker
T_, use an RF coaxialcableto
connect theVCR's RF OUT Jack
to the TV'sANTENNA IN Jack.
Press the PLAY • or STOP • button to selectVCR SET
UP, then press the FF I_/OK button.
_' ON SCREE_ MODE ON
TIMER REC SPEED MANUAL
VIDEO ETABIUZER OFF
PICTURE NORMAL
AUDIO OUT HIR
STEREO/SAP STEREO
END FUSPI EXIT
3 "
Press the PLAY • or STOP • button to select
STEREO/SAP, then press the FF I_IOK button to select
SAP or STEREO, whichever you prefer.
4
Press the EXIT/STATUS button.
5
Use the CH(annel) •/V buttons to select a channel.
6
Press the SPEED button to select the tape speed.
•
Pre_s the REC(ord)IOTR button to start recording.
• If youwantto connect t heVCRto a
Stereo T V, f ollow these steps.
I) Connectthe antennaor cable
signal t o the VCR's A NT(enna) IN
]aclc
2) Usestereoaudiocables to con-
nectthe VCR's A UDIO OUTJacksto
TV'sAUDIOIN ]acks.
3) Usea videocableto connect t he
VCR's VIDEOOUT Jackto the TV's
VIDEOIN Jack.
• Make surethe "IVand the Stereo(if
applicable) a re in LineInput or
Auxi/iarymode.Pleaserefer to your
TV or Stereoowner'smanualfor
details.