Table of Contents
Advertisement
tO iTuming on
Your V CR:
Before turning on yourVCR, make sure there are batteriesin the
remote control and theVCR,'I'_, and Cable Box/DBS(if applicable) _
_
Turn on the T_.
are connectedand pluggedin.
'
a_
I
6
Wa_ f°r theVCR t° set up
Press the VCR button, then press the POWER button,
channels.
2
Turn on theTV.
Set it to channel 3 or 4, whichever the
CH31CH4 switch on the back of tEeVCR is set to. The
menu shown below will appear.
TOvcRCI_INECT ANTENNA
OR CABLE
THEN PUSH I_/OK KEY
OR...
R M.AY ONLY - FUSH STOP
-
5
Press the FF I_IOK button to begin automatic channel
setup. AUTO CH. SET PROCEEDING PLEASEWAIT will appear
on-screen.TheVCR will memorize all of the channels you receive,
so when you scanthrough channelsusing the CH(annel) A/V but-
tons, you'll only scanthrough channelsthat you receive.
6
When channels are set up,AUTO CH. SETCOMPLETED will
appear briefly on screen.
Auto may appearon the display
)anel un_lthe dock is set.After
,ou connect t he antonna/cable s ig-
nal to the VCRand connectthe VCR
to a power source, the clockmay
set i_elf automa_cally. The current
time may appearon theVCR dis-
playpanel.
If youdo not wantto set up chan-
nelsnow,press_heSTOP• button
at step 5. TUNER NOT SETwill
appear briefly on screen.
Youmay not set up channelsat
stepS if you are using a'Cable
Box/DES.
Advertisement
Table of Contents
