Table of Contents
Advertisement
Using the Foot Switches
Assigning modules to
foot switches 1 – 4
In manual mode, the foot switches 1 – 4 can be
used to turn specific modules on and off. This
section explains how to assign modules to the
switches.
1.
In manual mode or play mode,
select the patch.
HINT
Functions assigned to the foot switches 1 – 4 are
specifi c to each patch.
2.
Press the [FOOT SW] key twice.
The display changes as follows.
Press key twice
Modules assigned to the foot switches 1 – 4
HINT
The foot switch 1 – 4 setting is included in the
TOTAL/FUNCTION module for the patch. The
above display can also be called up by pressing
the [TOTAL/FUNCTION] key in the effect
module key section and then turning the [TYPE]
knob.
3.
Use the parameter knobs 1 – 4
to select the function for foot
switches 1 – 4.
The parameter knob number corresponds to the
foot switch number.
For example, to select a module to assign to foot
switch 1, turn parameter knob 1.
The following modules can be assigned to the
respective foot switches.
• Foot switch 1
C OM P m o du le (C M P) o r WA H / E F X1
module (WAH)
38
• Foot switch 2
PRE-AMP module (AMP) or EXT LOOP
module (ExL)
• Foot switch 3
MOD/EFX2 module (MOD) or EQ module
(EQ)
• Foot switch 4
DELAY module (DLY) or REVERB module
(REV)
HINT
The names of the two modules that can be
assigned to each foot switch are printed on the
panel to the right of the switch. The currently
selected module is indicated by the respective
LED which is either lit (module on) or fl ashing
(module off).
NOTE
Any changes in assignment settings will be lost
when you select a new patch. Be sure to store
the patch if you want to keep the changes (
27).
Specifying the tempo
for a patch
The B9.1ut lets you specify a tempo for each
individual patch and synchronize specific
parameters to this tempo in note units. This
section explains how to specify and use the
tempo setting for a patch.
1.
In manual mode or play mode,
select the patch.
2.
Press the [TOTAL/FUNCTION]
effect module key.
The tempo setting for each patch is part of the
[TOTAL/FUNCTION] module.
When you press the [TOTAL/FUNCTION]
effect module key, the display changes as
follows.
p.
→
ZOOM B9.1ut
Advertisement
Table of Contents
