Zoom B9.1ut Operation Manual page 37

Time parameter value (delay time).
• To use Delay TAP, the DELAY module must be
active for that patch.
● Hold Delay
The function foot switch toggles hold delay
between on and off. When you press the
function foot switch in a patch for which hold
delay is active, the hold function is turned
on and the current delay sound is repeated.
Pressing the function foot switch once more
cancels hold, and the delay sound will decay
naturally (see the following illustration).
HINT
To use HOLD DELAY, the DELAY module must
be active for that patch.
● Delay Mute
The function foot switch toggles DELAY
module input muting between on and off.
HINT
To use Delay Mute, the DELAY module must be
active for that patch.
● Hold Synth
The function foot switch toggles Hold Synth
between on and off. When this function
is assigned and the function foot switch is
pressed for a patch where Hold Synth is
enabled, the function becomes on and the
current bass sound is held. Pressing the
function foot switch once more releases the
hold condition, and the bass sound stops.
[Hold Delay]
Original
sound
Function foot switch pressed
ZOOM B9.1ut
Delay sound
Using the Foot Switches
HINT
To use the Hold Synth function, "MonoSyn" or
"4VoiceSyn" must be selected as effect type in
the PRE-AMP module of the patch.
● COMP OnOff, WAH OnOff, ExLopOnOff,
ZNR OnOff, AMP OnOff, EQ OnOff, CAB
OnOff, MOD OnOff, DELAYOnOff, REV
OnOff
T h e f u n c t io n fo o t s w it c h t og g l e s t h e
respective module between on and off.
● TunerDsply
The function foot switch calls up the tuner
display without bypassing the effects.
● P-H Disable
The function foot switch enables/disables the
horizontal action of the expression pedal.
HINT
• When "BPM TAP" or "Delay TAP" is selected,
the function foot switch LED fl ashes red in
sync with the BPM setting.
• It is also possible to assign the same function
to multiple function foot switches.
4.
After selecting a function to assign
to the function foot switch, press
the [EXIT] key.
NOTE
Any changes in assignment settings will be lost
when you select a new patch. Be sure to store
the patch if you want to keep the changes (
27).
Hold
Switch pressed again
p.
→
37