Table of Contents
Advertisement
MIDI Usage Examples
pressed, and note off is sent when the foot
switch is pressed once more.
HINT
For more information on the pedal synth
function, see page 55.
4.
When the setting is complete,
press the [EXIT] key to cancel the
SYSTEM menu.
I f a set t i ng was cha nge d, t he i nd icat ion
"Store...?" appears on the display, to allow you
to store the changes.
If no setting was changed, the unit returns to the
previous mode.
5.
Press the [STORE/SWAP] key to
save the changes.
The setting is accepted, and the unit returns to
manual mode or play mode.
By pressing the [EXIT] key, you can abort the
changes and return to play mode without saving.
HINT
To send note on/note off information, make
connections as shown in step 7 of "Assigning
control change numbers" (
Sending and receiving
B9.1ut patch data via MIDI
The patch data stored in a B9.1ut can be sent and
received as MIDI messages (system exclusive).
When two B9.1ut units are connected via a
MIDI cable, this allows copying of patch data
from the sending unit to the receiving unit.
NOTE
When patch data are received, all existing
patch data in the B9.1ut will be overwritten.
Perform the following steps with care, to avoid
accidentally overwriting important data.
1.
Connect the MIDI OUT connector
on the source B9.1ut to the MIDI
IN connector on the target B9.1ut
50
p. 47).
→
using a MIDI cable.
MIDI
MIDI
IN
OUT
The steps at the target B9.1ut and source B9.1ut
are explained separately below.
■ Target B9.1ut
2.
Set the B9.1ut to manual mode or
play mode.
If the unit is in another mode or shows another
display, press the [EXIT] key to return to the
manual mode or play mode.
■ Source B9.1ut
3.
Set the B9.1ut to manual mode or
play mode and press the [SYSTEM]
key.
4.
Use the [TYPE] knob to bring up
the "BulkDumpTx" (bulk dump
transmit) parameter on the display.
[TYPE] knob
5.
Press the [STORE/SWAP] key.
The sending of patch data begins.
MIDI
MIDI
IN
OUT
ZOOM B9.1ut
Advertisement
Table of Contents
