Table of Contents
Advertisement
Switching Modules On and Off
The condition where foot switches 1 – 4 are used to switch the modules in the currently selected patch
on and off individually is called "manual mode". When turning on the B9.1ut, it will start up in this
mode.
Panel display
Group name/Bank number/Patch number
The group name "P" indicates the preset group, and the group name "U" the user group.
Bank number
(0 – 9, A – J)
Patch number
(1 – 4)
When the module assigned to the foot switch is on, the LED is lit.
When the module is off, the LED flashes.
Selecting patches
This section explains how to select patches in
manual mode.
1.
Make sure that the [MANUAL] key
is lit.
Immediately after power-on, the [MANUAL]
14
Patch name
Functions assigned to function
foot switches 1 – 3
Effect module keys
Keys for modules that are active in the currently selected patch
are lit in red.
Foot switch 1 – 4 LEDs
Foot switch 1 – 4 LEDs
In manual mode, the following information is
shown on the panel.
"E" symbol
If a setting of the currently selected
patch differs from the original
setting, the indication "E" (for
Edited) appears.
Shows the operation that will be carried out
when pressing the respective function foot
switch (→ p. 36).
key will be lit and the B9.1ut will be in manual
mode. If the key is out, press it so that it lights
up.
[MANUAL] key (lit)
(Manual Mode)
ZOOM B9.1ut
Advertisement
Table of Contents
