Effect Types And Parameters; How To Read The Parameter Table - Zoom B9.1ut Operation Manual

Effect Types and Parameters

How to read the parameter table

Effect module
Effect type
Delay
This is a long delay with a maximum setting of 5000 ms.
PingPongDly (Ping Pong Delay)
This is a ping-pong type delay where the delay sound alternates between left and right.
This effect simulates an analog delay with a long delay time of up to 5000 ms.
The above fi ve effect types have the same parameters.
PARM1
Time
Sets the delay time.
ReverseDelay
This is a reverse delay with a long delay time of up to 2500 ms.
PARM1
Time
Sets the delay time.
Tempo sync
The note symbol (
the patch specific tempo. If you select the note symbol as a value for the parameter
when making the setting at the B9.1ut, the parameter value will be synchronized to
the patch specific tempo in note units (→ p. 38).
Expression pedal
The pedal symbol (
with the built-in expression pedal. If you select the parameter as control target when
making the setting at the B9.1ut (→ p. 31), the expression pedal will adjust the
parameter in real time when the patch is selected. Parameters with the pedal symbol
can also be selected as control targets for the ARRM function.
Delay tap/hold delay/delay mute/hold synth
The ,
respective function foot switch 1 – 3 can be used to specify the delay time (TAP),
toggle hold delay on and off (HOLD), toggle delay mute input between on and off
(MUTE), and toggle hold synth on and off (SYNTH). These functions apply to the
DELAY module (TAP, HOLD, MUTE) or the PRE-AMP module (SYNTH).
To use these functions, the respective function must be assigned to the function foot
switch 1 – 3 (→ p. 36) and the respective effect type must be enabled.
64
Effect parameters 1 – 4
When this effect type is selected, the four parameters listed here
can be adjusted with parameter knobs 1 − 4. The setting range
for each parameter is also shown. Some effect parameters are
adjusted with the knobs of the pre-amp section.
DELAY module
This is a delay module that allows use of the hold function. Effect parameters are described after the listing of
effect types.
PARM2
1 – 5000ms 0 – 100
FeedBack
Adjusts the feedback amount.
PARM2
10 – 2500ms FeedBack 0 – 100
Adjusts the amount of feedback.
) in the table indicates that the parameter can be synchronized to
) in the table indicates that the parameter can be controlled
, , and
PARM3
HiDamp 0 – 10
Adjusts the treble attenuation of the Adjusts the balance between
delay sound. original sound and effect sound.
PARM3
HiDamp 0 – 10
Adjusts the treble attenuation of the Adjusts the balance between
delay sound. original sound and effect sound.
indications in the table show that the
PARM4
0 – 100
Mix
PARM4
Balance 0 – 100
ZOOM B9.1ut