Zoom B9.1ut Operation Manual page 45

5.
Press the [STORE/SWAP] key to
save the changes.
The setting is accepted, and the unit returns to
manual mode or play mode.
By pressing the [EXIT] key, you can abort the
changes and return to play mode without saving.
6.
To send and receive program
change (+ bank select) messages,
connect the B9.1ut and the other
MIDI device as follows.
[Example for sending program change
(+ bank select) messages]
(2) Program change (+ bank select)
message is sent
MIDI OUT
connector
(1) When a patch at the B9.1ut is switched...
[Example for receiving program change
(+ bank select) messages]
(1) When a program change
(+ bank select) message is
received...
MIDI IN
connector
(2) Patch at the B9.1ut is switched.
NOTE
When the external MIDI device sends only a
bank select message to the B9.1ut, no change
occurs. The next time the B9.1ut receives a
program change, the most recent bank select
instruction will be used.
ZOOM B9.1ut
■ Using mapping mode
In this mode, a program change map is used to
assign patches, allowing patches to be specifi ed
by using program change messages only.
NOTE
1.
MIDI IN
connector
2.
[TYPE] knob
3.
MIDI OUT
Patches can now be specified using program
connector
change messages according to the program
change map.
Parameter knob 1
4.
Using this display, you can assign any patch of
the B9.1ut to a program change number from 0 –
127.
MIDI Usage Examples
Before carrying out the following steps, verify
that the send/receive MIDI channel setting of
the B9.1ut is as required (
send/receive of program change messages is
enabled ( p. 43).
→
In manual mode or play mode,
press the [SYSTEM] key.
Turn the [TYPE] knob to bring up
the "MIDI PCMODE" (program
change mode) parameter.
Turn parameter knob 1 to bring up
the indication "MAPPING".
Turn the [TYPE] knob to bring up
the "PC MAP" (program change
map) parameter.
p. 42), and that
→
45