Changing The Insert Position Of The Pre-Amp Section And Wah/Efx1 Module - Zoom B9.1ut Operation Manual

Linking Effects
Changing the insert position
of the pre-amp section and
WAH/EFX1 module
The B9.1ut allows you to change the insert
position of the fi ve modules making up the pre-
amp section (EXT LOOP, ZNR, PRE-AMP, EQ,
CABINET) and the WAH/EFX1 module. This
will result in changes to the effect action and
tone.
■ Changing the insert position of the
WAH/EFX1 module
To change the insert position of the WAH/EFX1
module, call up the Position parameter and set it
to "Befr" (before pre-amp section) or "Aftr" (after
pre-amp section). The Position parameter can be
used when the Octave, Tremolo, Defret, Splitter,
or X-Vibe effect type is not selected.
1.
In manual mode, play mode, or edit
mode, press the [WAH/EFX1] key.
2.
Turn the [TYPE] knob and select
an effect type other than Octave,
Tremolo, Defret, Splitter, or X-Vibe.
3.
Turn parameter knob 1 to select
"Befr" (before pre-amp section) or
"Aftr" (after pre-amp section).
Parameter knob 1
4.
When the setting is complete,
press the [EXIT] key.
The unit returns to the previous mode. To enable
the changed setting, be sure to store the patch (
p. 27).
62
■ Changing the insert position of the pre-
amp section
To change the insert position of the pre-amp
section, call up the Chain parameter and set it
to "Pre" (before MOD/EFX2 module) or "Post"
(after DELAY module). The Chain parameter
can be used with all effect types except for bass
synth effects.
1.
In manual mode, play mode, or edit
mode, press the [PRE-AMP] key.
The display changes as follows.
2.
Turn the [TYPE] knob and select
an effect type other than a bass
synth effect.
3.
Turn parameter knob 3 to select
"Pre" (before MOD/EFX2 module)
or "Post" (after DELAY module).
The display changes as follows.
Parameter knob 3
4.
When the setting is complete,
press the [EXIT] key.
The unit returns to the previous mode. To enable
the changed setting, be sure to store the patch (
p. 27).
NOTE
• When the "Pre" setting is selected as pre-
amp section insert position, the signal after
the MOD/EFX2 module is processed fully in
stereo. When you select "Post", the signal is
processed in the pre-amp section in mono.
• When a synthesizer effect type (StdSyn,
SynTlk, V-Syn, MonoSyn, 4VoiceSyn,
→
PedalSyn) has been selected for the PRE-AMP
module, the Chain parameter cannot be used.
With a synthesizer effect type, the synth sound
is processed by the effects after the PRE-AMP
→
ZOOM B9.1ut