Table of Contents
Advertisement
Effect Types and Parameters
4VoiceSyn (4-Voice Synthesizer)
This effect type adds synthesizer harmony components to single notes played on the bass. The harmony components are determined by the
Mode and Scale parameters.
GAIN
Attack
Adjusts the attack rate of the synthesizer sound.
PARM1
Mode
Selects a harmony type from 1 - 9.
Note played
on bass
Scale1
C
7 (omit 5)
C
MaJ7 (omit 5)
F
PedalSyn (Pedal Synthesizer)
This is a synthesizer that can be played with the foot switches of the B9.1ut. When this effect type is selected, the foot switches operate
differently from normal mode. For details, see page 56.
GAIN
Decay/Atk
Adjusts the rate of sound change. The target parameter is Decay in trigger
mode and Attack in hold mode.
PARM1
M-TG, m-TG,
Scale&Mode
C-TG, M-HD,
m-HD, C-HD
Selects the scale (M/m/C) and the
sound generation mode (TG/HD)
(→ p. 56).
EQ (Equalizer) module
This is a 6-band equalizer. In edit mode, the module is adjusted using the [SUB-BASS], [BASS],
[LO-MID], [HI-MID], [TREBLE], and [PRESENCE] knobs of the pre-amp section.
Sub-Bass
Adjusts the very low frequency range.
Bass
Adjusts the low frequency range.
Lo-Mid
Adjusts the low midrange frequency range.
Hi-Mid
Adjusts the high midrange frequency range.
70
0 – 10
Level
Adjusts the signal level after passing the
module.
1 – 9
Scale
Selects a harmony variation. For each of the
parameter 1 - 9 modes, two variations are
available. (See illustration below.)
(Example: C)
Scale 2
C
C
m
C
m7 (omit 5)
C
m MaJ7 (omit 5)
C
F
C
on
on
C
C
1 – 100
PARM2
Key
C1 – B3
Selects a keynote for pedal synth
playing.
LEVEL
1 – 100
PARM2
1, 2
Adjusts the balance between original sound and
effect sound.
Scale1
C
dim
C
7
C
MaJ7
9
C
sus4
LEVEL
1 – 100
Level
Adjusts the signal level after
passing the module.
PARM3
Saw0 – 9,
Variation
Pulse0 – 9,
PWM0 – 9
Selects the waveform type and
sound variation. Available settings
are "Saw" (sawtooth), "Pulse"
(square wave), or PWM (pulse
width modulation resulting in fatter
sound).
PARM3
MixBal
0 – 100
Scale 2
E
dim
F
7
F
MaJ7
C
add9
PARM4
MixBal
0 – 100
Adjusts the balance between
original sound and effect sound.
ZOOM B9.1ut
Advertisement
Table of Contents
