Select Module To Edit; Switch Effect Modules On And Off - Zoom GFX-4 Operation Manual

Operation Guide 2
The GFX-4 allows you to edit patches both in program mode and manual mode.
In program mode, the display will revert to its original condition about 5 seconds after the last
editing operation was performed. In manual mode, the display remains unchanged after the last
editing operation.
In manual mode, the foot switches 1 - 3 can be used to switch effects on and off.
To activate manual mode, press the MANUAL key in program mode.
1

Select module to edit

Use the module keys to select the module that you want
to edit.
The LED of the selected module flashes in red. The display shows the
following information.
When module is on
When a module is set to off, it cannot be edited. Turn the
module on first.
2

Switch effect modules on and off

To toggle the selected module between on and off, press the FX
panel key corresponding to that module.
In manual mode, module on/off
switching can also be performed
with foot switches 1 - 3.
The modules are assigned to FX
panels 1 - 3 as shown at right.
10
ZOOM GFX-4
Editing Patches
When module is off
COMP/OD/ENV,
DRIVE,
MODULATION
EQUALIZER
modules
FX panel 1 FX panel 2
PEDAL,
DELAY/REVERB
modules
modules
FX panel 3