Setting The Operation Of The External Exp Pedal (Exp1, 2 Function) - Boss GT-PRO Owner's Manual

Value Explanation
Amp Ctl2 On/Off
Switches the AMP CTL 2 on and off.
Switches the Manual Mode (p. 85) on and
MANUAL On/Off
off.
TUNER On/Off Switches the TUNER/BYPASS on and off.
Master BPM (TAP) Used for tap input of the Master BPM.
Delay Time (TAP) Used for tap input of the delay time.
Controls the Start/Stop of external MIDI de-
MIDI Start/Stop
vices (such as sequencers).
Controls the Play/Stop of external MIDI de-
MMC Play/Stop
vices (such as hard disk recorders).
Patch Level Inc1
Increases the patch volume level by 10 units.
Patch Level Inc2
Increases the patch volume level by 20 units.
Decreases the patch volume level by 10
Patch Level Dec1
units.
Decreases the patch volume level by 20
Patch Level Dec2
units.
Switches Hold recording (dubbing) on and
Hold Dly Rec/Dub
off when "Hold" (p. 32) is selected for the
delay type.
When "Hold" is selected for the delay type, the
Hold Dly Stop
performance is instantly stopped.
Switches the preamp SOLO, for both chan-
nel A and B, on and off.
Solo A&B On/Off
* If one of the two channels is off, both will be
turned on.
Switches to the next higher patch number in
Patch Num. Inc
the same bank as the currently selected
patch.
Switches to the next lower patch number in
Patch Num. Dec the same bank as the currently selected
patch.
Patch Bank Inc Switches to the next higher bank number.
Patch Bank Dec Switches to the next lower bank number.
Chapter 6 Using Pedals to Control the Effects
Setting the Operation of the External
EXP Pedal (EXP1, 2 Function)
This applies the setting determining the function of the EXP
pedals connected to the EXP PEDAL 1 and EXP PEDAL 2
jacks as global settings for the entire GT-PRO.
fig.06-0050
1. Press [SYSTEM].
2. Press PARAMETER [
or "EXP2 Func" is displayed.
fig.06-0060d
3. Use the PATCH/VALUE dial to select the external EXP
pedal function.
4. Repeat Steps 2 and 3 as needed.
5. Press [EXIT] to return to the Play screen.
Value
Auto
(EXP1 Func only)
When Pedal Wah and Pedal Bend are switched off, this automatical-
ly functions as a "foot volume" pedal.
Assignable
Foot Volume
Patch Level
Pedal Wah
Pedal Bend
3 2 1
5
] [ ] so that "EXP1 Func"
Explanation
The pedal normally is used as a "foot vol-
ume" pedal. When Pedal Wah (p. 36) or
Pedal Bend (p. 47) is switched on, the EXP
pedal then automatically functions as a
"pedal wah" or "pedal bend" pedal.
The pedal is used as the controller set in As-
sign (p. 66) for each patch.
The pedal functions as a "foot volume" pedal.
The pedal is used as the patch level controller.
The pedal is used as a "pedal wah" pedal
when Pedal Wah is switched on.
The pedal is used as a "pedal bend" pedal
when Pedal Bend is switched on.
63