Using The Identical Preamp Settings In All Patches (Preamp Mode); Setting The System Preamp; Limiting The Patches That Can Be Switched (Patch Extent) - Boss GT-PRO Owner's Manual

Chapter 10 Other Features
Using the Identical Preamp Settings
in All Patches (Preamp Mode)
With the GT-PRO, you can have a preamp be set globally for
use in all patches.
This provides an effect that always gives you the sound of
the same guitar amp regardless of the patches you set.
fig.10-0300
1. Press [SYSTEM], then press PARAMETER [
[ ] so that "Preamp Mode" is displayed.
fig.10-0310d
2. Rotate the PATCH/VALUE dial to change the setting's
value.
Value Explanation
The patch preamp setting is used. This al-
Patch
lows you to use different preamp settings
in each individual patch.
The system's preamp setting is used. This
System
applies the same preamp settings to all
patches.
3. Press [EXIT] to return to the Play screen.

Setting the System Preamp

When the Preamp Mode is set to System, preamp settings
made by adjusting the panel controls are treated as system
preamp settings.
The stored content is updated each time the settings are
changed.
98
2 1 1
3
]
Limiting the Patches That Can Be
Switched (Patch Extent)
By setting an upper limit to the patches, thus limiting the
range of patches that can be switched, you can set the GT-
PRO so that only the patches you need can be selected.
fig.10-0320
1. Press [SYSTEM], then press PARAMETER [
[ ] so that "Patch Extent" is displayed.
fig.10-0330d
2. Rotate the PATCH/VALUE dial to set the upper limit
for the Patches.
Valid Settings: 1-1–40-10
* The bank numbers indicated are lowered by one when FC-200
mode (p. 81) is switched on, so U0-1 to P39-10 is displayed.
3. Press [EXIT] to return to the Play screen.
2 1 1
3
]