Switching The Output/Input Level; Main Out Level; Sub Out Level; Loop 1/2 Send Level - Boss GT-PRO Owner's Manual

Chapter 10 Other Features

Switching the Output/Input Level

You can switch between the MAIN OUT, SUB OUT, and
LOOP 1/2 SEND output levels and the LOOP 1/2 RETURN
input levels.
Switch levels according to the connected device.
fig.10-0380
1. You can display the level switching screen by pressing
[SYSTEM] and then pressing PARAMETER [
[ ].
2. Use the PATCH/VALUE dial to switch the output level.
Valid Settings: +4 dBu, -10 dBu
3. Press [EXIT] to return to the Play screen.

MAIN OUT Level

fig.10-0390d

SUB OUT Level

fig.10-0400d
* The SUB OUT R/L (XLR type) connectors are unaffected by
the SUB OUT level. Signals are always output at a fixed
level (+4 dBu).

LOOP 1/2 SEND Level

fig.10-0410d

LOOP 1/2 RETURN Level

fig.10-0420d
100
2 1 1
3
]
Checking the Effect Level
with the Level Meter
You can meter the output level of each effect. This is handy
for checking the effects' output levels.
fig.10-0430
1. Press [SYSTEM] several times so that "METER" is
displayed.
fig.10-0440d
2. Rotate the PATCH/VALUE dial to select the effect
whose level you want to check.
• You can check the level of signals being input to the
INPUT jack by selecting "Input."
• Selecting "Main Out" allows you to check the level of
signals output from the MAIN OUT.
• Selecting "Sub Out" allows you to check the level of
signals output from the SUB OUT.
* You may not be able to achieve the effects you envision if your
output levels are set too high. Adjust the output level of each of
your effects to the optimum value while checking the meter
and making sure the needle doesn't swing too far to the right.
3. Press [EXIT] to return to the Play screen.
For more information on the following system settings,
refer to p. 62–p. 65.
SYS: EXP 1 Func
SYS: CTL 1 Func
SYS: CTL 2 Func
SYS: EXP 2 Func
SYS: CTL 3 Func
SYS: CTL 4 Func
2 1 1
3
SYS: CC#7 Func
SYS: CC#80 Func
SYS: CC#1 Func