Setting The Special Driver's Functions; Adjusting The Audio Latency; Using Asio Direct Monitor - Boss GT-PRO Owner's Manual

Setting the Special Driver's Functions

Adjusting the audio latency

When using the GT-PRO in Advanced mode, you can change the driver settings to adjust the latency of the audio.
To adjust the latency, change the Buffer Size in the driver settings dialog box.
1
As described in "Opening the special driver settings dialog box" (p. 142), open the "Driver Settings" dialog box.
2
Adjust the driver buffer size.
The following setting will produce the shortest latency.
Windows:
Set Audio Buffer Size to the far left (Min).
Macintosh:
Set Buffer Size to the far left (Min).
3
Click [OK] to close the driver settings dialog box.
4
Restart the application that is using the GT-PRO.
If you are using an application that has a function for testing audio devices, get it to perform its tests.
5
Play back audio data on your application.
If interruptions occur in the sound, repeat this procedure, and gradually increase the buffer size specified in step 2 until
interruptions no longer occur.
* Depending on the application you are using, there may be a buffer size or latency adjustment function among the audio settings of the
application as well. For details, refer to the operation manual for your application.

Using ASIO Direct Monitor

If you are using the GT-PRO from an ASIO 2.0 compatible application, switching of the GT-PRO's output signals (Direct
Monitor; p. 90)) can be controlled from your ASIO 2.0 compatible application.
1
As described in "Opening the special driver settings dialog box" (p. 142), open the "Driver Settings" dialog box.
2
Check the Use ASIO Direct Monitor check box.
3
Click [OK] to close the driver settings dialog box.
* Depending on the application you are using, there may be a ASIO Direct Monitor among the audio settings of the application as well.
For details, refer to the operation manual for your application.
* When using ASIO Direct Monitor, monitoring may switch on/off at unexpected times, depending on the application settings and on
the recording procedure. If this occurs, uncheck the check box in step 2 to disable ASIO Direct Monitor.
141