Adjusting The Picture Quality - Denon DVD-2200 Operating Instructions Manual

ADJUSTING THE PICTURE QUALITY
2,3,4,5,7,8--
2,&9i
®®00
0000
o©_ 1
1
2
3
Press tile PIC.ADJ button during playback,
Use the _ and _ cursor buttons to select tile picture
memory, then press the ENTER button.
,, Tile display switches as follows:
STD (SFANDARD) <-->M1 (MEMORY 1) <-> M2 <->
M3 <-->M4 <--_M5
STD (Factory defaumt)
Wher/this is selected, both the picture quality and
function are reset to factory setting,
M1 ~ M5
Picture quality settings you have adiusted car) be
stored here.
Select the item to change using _ and _ buttons.
ADJUST MODE -_
+ Tile con[rast, brightness, sharpness and color (HUE)
can be adjusted,
+ Perform steps 4 ~ 6 to adjust the picture quality
(ADJUST MODE),
GAMMA
+ Sebct this if dark portions of the picture are too dark
or bright portions are too bright.
+ Perform steps 7 ~ 9 to adjust the gamma correction
(GAMMA).
Press the T cursor button to select the adjust mode,
then use the _ and _ cursor buttons to select the
Remote control unit
Remote control unit
Remote control unit
PIC ADJ
%
Remote control up,it
image quality adjustn_ent item.
CONTRAST _ (-6 ~ +6)
Adjusts the contrast of tile image,
BRIGHTNESS R_ (0 ~ +12)
Adjusts the picture's brightness,
SHARPNESS C3 (=6 ~ +6)
Adjusts the sharpness of the picture,
HUE _g_ (=6 ~ +6)
Remote control unit
Remote control unit
Adiusts the balance of the green and red. (This does
not affect Progressive Scan images and the component
video out.)
- ii+iil+@+iii,ii,iiiiiiiiiiiiii@
43