Adjusting The Picture Quality (Picture Control) - Denon DVD-A1UD Owner's Manual

Adjusting the Picture Quality (Picture Control)

You can adjust the picture quality to your liking.
You can store up to a maximum of 5 values in memory.
1
Press .
The currently set status is displayed.
2
Select the memory number you want ("Memory 1" ~
"Memory 5") with , and then press
Memory 5
PICT
Standard
Memory 1
3
Select the item you want to change
with .
Memory 1 V.Position 0
0
DNR
Contrast 0
4
Change the setting with .
Refer to the table on the right regarding contents of items which
b
can be set.
When Finishing Picture Adjustment
n
Press during picture adjustment.
When Outputting Standard Picture Quality without
n
Using Picture Adjustment
Press and to select "Standard" and then press
The picture adjustment set values are retained in memory even after
the power is turned off.
Setting
Setting items
contents
DNR
Reduce noise in the entire 0 ~ +3
picture.
Contrast
–6 ~ +6
.
Adjust picture contrast.
Brightness
0 ~ +12
Adjust picture brightness.
Enhancer
Strengthens the contours of 0 ~ +11
the picture.
Gamma Correction
Adjust video brightness in
G0 ~ 9
detail.
Sharpness (medium range)
z 1
–6 ~ +6
Adjust picture sharpness
for the medium frequency
range.
Sharpness (high range)
–6 ~ +6
Adjust picture sharpness for
the higher frequency range.
Hue (color tone)
–6 ~ +6
Adjust the green and red
color balance.
.
White Level
–5 ~ +5
Adjust the white level.
Black Level
–5 ~ +5
Adjust the black level.
Chroma Level
–6 ~ +6
Adjust the color density.
Setup Level z 2
0 IRE
Adjust the black areas of the
7.5 IRE
image.
H.Position
–7 ~ +7
Adjust the left/right position.
V.Position
Adjust the top/bottom –7 ~ +7
position.
z1：This is not available for HDMI output.
z2： Effective only for the 480i video signal from the video output terminal, S
video output terminal, and component video output terminal.
About Gamma Correction
Default
When you select "Gamma Correction", and then press
change the setting with
0
In the example of the graph below, the horizontal axis shows the
brightness level of the pictured recorded on the disc. The vertical axis
0
shows the brightness of the picture output by the DVD-A1UD.
0
255
0
G0 = 24 / G1 = 32
G2 = 48 / G3 = 64
G4 = 80 / G5 = 96
0
0
G6 = 128 / G7 = 160
G8 = 192 / G9 = 224
• On adjusting the brightness on the output side of bright parts on
the disc side, the normally hard to see bright parts become clearly
discernible images.
0
255
0
0
0
0
0
• On adjusting the brightness on the output side of dark parts on
the disc side, the normally hard to see dark parts become clearly
0
discernible images.
Resuming Initial Values after Gamma Correction
0 n
Press while a graph is displayed.
0 IRE
0
0
ENGLISH
, you can
.
Memory 5 Gamma Correction
G0:024
255
Memory 5 Gamma Correction
G0:024
255