Denon DVD-2200 Operating Instructions Manual page 31

@ When "MUL]-I CHANNEL" is selected, use the a, and _ cursor
buttons to select the item to be set, then press the ENTER button.
SPEAKER CONFIGURATION
Use this to select the types of the different speakers.
CHANNEL LEVEL
Use this to adjust the output ]eve] of the different speakers,
DELAY TIME
Use this to set the distance from the different speakers to the
]isteHng position,
$ fo exit the SPEAKER SETUP mode
Use the Ir cursor button to select "AUDIO SETUP" then press
ENTER button.
$ The SPEAKER CONFIGURAq-ION settings only apply to analog
outputs.
,_ When "SPEAKER CONFIGURAq-ION" is sebcted, use the & and T
cursor buttons to select the speaker to be set then press the ENTER
button.
* The type of speaker used for the front speakers, center speaker,
subweofer and surround speakers (:an be set. Use the A and
cursor buttons to select the speaker type, then press the ENTER
button.
LARGE
Select this whorl a large speaker is connected,
SMALL
Select this when a small speaker is connected,
HONE
Select this when no speaker is connected.
YES
Select this when a subwoofer is connected,
He
SeJect this when no subvvoofer is connected,
,_ When "FILq-ER" is sebcted:
OH (Factory defauJt}
Set to "ON" to play sources in the Dolby Digital and PCM multi-
channel modes,
OFF
DTS recornmended all-channel full band playback setting. (Note
however that tile subvvoofer vekJme increases by 5 dB, by 15 dB
when playing Super Audio CDs,)
Set this to play DVD audio 6-channel sources recorded in alPchanne]
fuji band frequencies.
When "OFF" is set, tile speaker size is set to "LARGE" for aH tile
speakers and the subwoofer setting is set to "YES",
To play this type of disc, read the disc's instructions carefully and
make analog connections.
$ Press the RETURN button to return to the "SPEAKER SETUP"
men u,
,_ When "CHANNEL LEVEL" is sebcted, use the A and T cursor
buttons to select the speaker to be adjusted, then use the _ and I_
cursor buttons to set the level
SW +10 dB
Depending on the connected amplifier, it may not be possible to
increase the subwoofer level to balance it with the level of other
chahne]s. In this case, the SW +10 dB function carl be used to
boost the subwoofer output.
When turned on, the subwoofer output is increased by +10 dB.
$ Never play at high sigha] levels (full scale or near fish scale)
when the SW +10 dB n/ode is turned on. The signal level could
exceed the amplifier's tolerance input ]eve], resulting in noise
that could daroage the speakers.
Remote control unit Rernote control unit
Remote control unit
31