Denon DVD-2200 Operating Instructions Manual page 33

@
When "SUPER AUDIO CD" is selected:
MULTI (Facterv default)
When playing Super audio CDs, the rnulti-channel area is played with
priority,
STEREO
When playing Super audio CDs, the stereo area is played with priority,
CD
When playing Super audio CDs, the CD layer is played with priority.
_ When playing discs that do not contain the selected area/layer,
another layedarea is played automatically.
@
When "DIGIFAL OUT" is selected:
NORMAL (FactorV defaultj
When playing DVDs recorded in Dolby Digital or DTS, bitstrearn signals
are output from the digital audio output terrninaJs, When playing DVDs
recorded in linear PCM or packed PCM, linear PCM signals are output,
Select "NORMAL" when making digital connections to an AV amplifier
with built-in Dolby Digital and DTS decoder,
PCM
When playing Dolby Digital/DTS bitstream signals or DVDs recorded in
linear PCM or packed PCM, the signals are converted into 48 kilT/1 B-
bit PCM (2-channel) signals and output from the digital outputs, When
playing DVDs recorded in PCM, linear PCM signals are output.
3
@ When "LPCM (44,1 kilT/48 kHz)" is selected:
OFF (Factory default}
When playing linear PCM or packed PCM DVDs that are not copyright-
protected, for 2-channel PCM audio signals up to 96 kHz, linear PCM
signals are output as such without being converted from the digital
outputs. (176,2 kHz and 192 kHz signals are converted to 88,2 kHz and
96 kHz, respectively.)
For DVDs containing muki-channel PCM signals, the digital signals are
down-mixed for output into two channels, front left and right, (Only the
front left and right channels are output for sources for which dowm
mixing is prohibited,)
When playing copyright-protected linear PCM or packed PCM DVDs, in
consideration of copyrights, no digital signals are output for sources
exceeding 48 kHz/16 bits. When playing such sources, either set to
"ON" or make analog connections. {See page 14.)
ON
Linear PCM and packed PCM signals are converted to 44.1 kHz or 48
kHz and output. {The PCM digital audio output signals are converted to
48 kHz or less in consideration of copyrights.) When making digital
connections to an AV amplifier that is not compatible with 96 kHz/88,2
kHz signals, set to "ON".
@
When "BASS ENHANCER (2 CHANNEL)" is selected:
OFF (Factory default)
No sound is produced frorn the subwoofer.
O[1
Sound is produced from the subwoofer.
In the case, set the subwoofer to "YES" at tile speaker settings.
-'_To exit the setup mode
Use the T cursor button to select "EXIT SETUP", then press the ENTER button, It is also possible to quit by pressing the SETUP button
on tile remote control unit.
33