4.
Remove the eight screws, four from each side, of the controller cage (see
3
Figure 127
Controller Cage/ Midplane Assembly Removal
5.
Remove the cage from the chassis: lift the top, front edge of the controller cage/
midplane assembly slightly upward
front until the connectors on the controller backplane exit the holes in the rear shield,
and lift the cage out of the chassis. (If the DC power harnesses were not removed earlier,
disconnect them prior to lifting the assembly out of the chassis).
2
1
(Figure
127), then pull the cage firmly toward the
Internal Controller Enclosure Assemblies
Figure
127).
357