front mount
A
screws
B door lock
C hinge block
D door flange
E mounting ears
F hinge arm
Figure 99
Disk Enclosure Front Door Removal and Replacement
4.
To replace the door, insert the bottom flange (D in
chassis between the gasket and bottom edge of the new door.
5.
Close and lock the door, letting the latch hold the door.
6.
Insert the right and left hinge blocks behind the disk enclosure mounting ears (E), lining
up all holes and inserting the hinge arm (F) over the pin on the bottom of the door.
7.
Insert and tighten two screws through each hinge block and disk enclosure chassis.
8.
Reinstall the disk enclosure in the rack. See
page
307.
Figure
99) of the disk enclosure
"Installing the Disk Enclosure SC10" on
Internal Disk Enclosure Assemblies
309