A - Tray ID switch
B - DIP switch
C - Fault LED
Figure 96
BCC Encloser (Tray) ID and DIP Configuration Switches
Once the disk enclosure is powered up, check the status of the disk modules using one of
the software management tools. Initially the disk modules status will be either "write
failed" or "no_response." Eventually, all the disk modules should return to "replaced"
status. Once this occurs, the disk array will perform a rebuild (a result of I/O occurring
during the period the enclosure was powered off). The disk array will operate at reduced
performance until the rebuild is completed.
C
Disk Enclosure Modules
303