Returned Values; Examples - HP StorageWorks P9000 - Disk Arrays Reference Manual

Option
-v pid
-v pid -FMRCF

Returned values

The pairdisplay command sets the following returned values during exit, allowing you to check the
execution results.
Normal termination:
1: The volume attribute is SMPL.
2: The volume attribute is P-VOL.
3: The volume attribute is S-VOL. When displaying groups, 1/2/3 = normal termination for all
pairs.
Abnormal termination (other than 0 to 127): See the execution log files for error details.

Examples

The following examples are of the pairdisplay command and its output.
Description
Finds the pool ID for each local and remote interconnected to the group via the specified group or
<raw_device>, and displays any information of each pool ID corresponding the local and remote.
The first line shows the pool information for the local host, second line shows the pool information
for the remote host. The displayed items are the same as for raidvchkscan -v pid.
Example:
# pairdisplay -g QS -v pid
PID POLS U(%) SSCNT Available(MB) Capacity(MB) Seq# Num LDEV# H(%)
127 POLN 0 6 3000 3000 63528 2 864 80
127 POLN 0 6 3000 3000 63528 2 864 80
# pairdisplay -g QS -v pid -l
PID POLS U(%) SSCNT Available(MB) Capacity(MB) Seq# Num LDEV# H(%)
127 POLN 0 6 3000 3000 63528 2 864 80
H(%): Displays the threshold rate being set to the Snapshot pool as High water mark. 'Unknown' is
shown as '-'.
Note: This option displays nothing if the target volume is NOT Snapshot volume.
The "-FBC [MU#]" option is used for displaying the pool information of cascading Snapshot volume,
so that you can know/monitor the pool status on remote host connected to cascading Cnt Ac-S_P-VOL
to Cnt Ac-S_S-VOL/Snapshot_P-VOL. It shows the pool information for the remote host only.
Example:
# pairdisplay -g QS -v pid -FMRCF
PID POLS U(%) SSCNT Available(MB) Capacity(MB) Seq# Num LDEV# H(%)
127 POLN 0 6 3000 3000 63528 2 864 80
pairdisplay 59