Raidcom Add Thp_Pool; Syntax; Options And Parameters - HP StorageWorks P9000 - Disk Arrays Reference Manual

raidcom add thp_pool

Creates a Pool for Thin Provisioning/Smart Tiers. Or, adds a pool volume. A device group can
also be specified instead of an LDEV.
When specifying a pool that is already created for Snapshot, the specified LDEV is added as a
pool volume.
Specify either one of pool ID or pool name certainly. If the specification of both pool ID and pool
name is omitted, it will be rejected with EX_REQARG.
This command is executed asynchronously with the command input. Check the completion of this
process on the raidcom get command_status command.

Syntax

raidcom add thp_pool {{-pool_id <pool ID#> [-pool_name <pool naming>] | -pool_name
<pool naming>[-pool_id <pool ID#>]} | -pool_id <pool ID#> -pool_name <pool naming>}
{-ldev_id <ldev#>
[<device name>]}[ -user_threshold <%> ]

Options and parameters

Option
-pool_id <pool ID#>
-pool_name <pool
naming>
-ldev_id <ldev#> ...
[ -cnt <count> ]
-grp_opt <group
option>
-device_grp_name
<device group name>
[<device name>]
[ -user_threshold
<threshold_1>
[<threshold_2>] ]
[-cnt <count>] | -grp_opt <group option> -device_grp_name <device group name>
Description
Specifies a pool ID (0- 1 27) for Thin Provisioning/Smart Tiers. When the specification of pool
ID is omitted, a pool name must be specified. When the pool name is specified and the pool
ID is omitted, a pool ID is allocated automatically.
Specifies an pool name of a pool for Thin Provisioning/Smart Tiers. Up to 32 characters can
be specified.
When the specification of pool name is omitted, a pool ID must be specified. When the pool
ID is specified and the pool name is omitted, a pool name is allocated automatically in the
form of "New Pool<number>".
Specifies an LDEV number (0-65279). Up to 64 of LDEVs can be specified at a time.
For example:
-ldev_id 100
-ldev_id 100 - 1 10
-ldev_id 100 -cnt 10
Specifies a count (2-64).
The count becomes singular if not specified.
Up to 64 of LDEVs can be specified at a time.
Specifies the device information extracted from the LDEV belonging to the device group. Specify
"ldev" (fixed). The information of LDEV belonging to the device group is used.
Specifies the name of device group (max. 32 characters) to be operated.
To operate an LDEV in the device group, specify the device name of LDEV (max; 32 characters)
within the device group.
If the device name is omitted, all the LDEVs belonging in the device group are operated.
You may specify two user-defined thresholds, and their valid ranges are 1- 1 00%, respectively.
If you specify <threshold_1> and <threshold_2>:
The value of <threshold_1> is set as the threshold for WARNING specified to a pool.
The value of <threshold_2> is set as the threshold for High water mark specified to a pool.
If you specify only <threshold_1>, your specified value and the system default value (80%) are
applied. If you omit to specify the value, 70% and 80% are applied automatically.
When you add a pool volume, this option is ignored even if it is specified. If you want to
change the user defined threshold value of the additional pool volume, execute the raidcom
modify pool command.
raidcom add thp_pool 187