Table Support Assembly - Craftsman 113.234700 Owner's Manual

Assembly
7. Lift front end of radial arm and slide
front table between radial arm and
frame, towards front. Do not let table
edges rest in notches of side frame.
8. Leave front table in place. Wrench
tighten rear bolt on each side where
side frame attaches to base.
9. Further tighten front bolt.
10. Remove front table.
11. Check that distance between radial
arm and frame is approximately same at
front and rear. Re-adjust if necessary.
Rear
Bolt Front
Bolt
Table Support Assembly
1. Set out:
-two table supports
-four carriage bolts s46"diameter by _"
-four s56" diameter flat washers
-four s/t6"diameter lock washers
-four s/t6"diameter nuts.
_5/16" x 1/2"
Carriage Bolt
5116"
Flat Washer
G
5/16"
Lock Washer
Table Support
Q
5116" Hex Nut
20