Craftsman 113.234700 Owner's Manual page 47

Crosscutting
8. Plug saw in.
9. Put yellow key in switch.
10. Grasp and hold onto saw handle,
then turn saw on.
11. Hold workpiece down and against
fence, keeping hand at least 6" away
from blade.
12. Hold hand in straight line with saw
handle and pull blade through fence
and workpiece only far enough to com-
plete cut, and never more than half
diameter of blade.
Fence
Workpiece
Yellow Key
13. Push blade carriage to rearmost posi-
tion, behind fence, and turn saw off.
Continue to hold saw handle until blade
stops spinning.
14. Remove yellow key and unplug saw.
47