Blade Safety Instructions; On-Product Safety Labels - Craftsman 113.234700 Owner's Manual

Safety
Blade Safety Instructions
1. Use only blades marked for at least
5500rpm.
2. Use only blades 8v4 inches in
diameter.
3. Use blades for their recommended
cutting procedures.
4. Keep blade sharp and clean.
5. Do not overtighten nut when securing
blade to saw because blade collar could
warp.
6. Do not turn saw on and off in rapid se-
quence because blade can loosen.
7. Blade should stop within 15 seconds
after saw is switched "off'. If blade takes
longer than 15 seconds to stop, the saw
needs repair. Contact Sears Service Cen-
ter.
On-Product Safety Labels
There are several safety labels on the
saw. They alert the user to hazards ex-
plained in the manual and remind the
user how to avoid the hazard.
Note where they are located on the saw.
Read and follow the safety information
and instructions in these labels. Refer
to the manual for detailed explanations
and instructions.
On the outfeed side of the guard are
these two safety labels to alert you to
wrong way feed:
DANGER
TO AVOID
INJURY DO NOT
FEED MATERIAL
INTO CUTTING
TOOL FROM
THIS END