Tools Needed For Assembly - Craftsman 137.322860 Operator's Manual

TOOLS NEEDED FOR ASSEMBLY

Supplied
Blade Wrench
COMBINATION SQUARE MUST BE TRUE
Should not gap or overlap when square is flipped over (see dotted figure).
Draw light line on
board along this edge.
Not supplied
Adjustable Wrench
8 mm, 10 mm
Hex Wrench
Combination Square
Should not gap or overlap when square
flipped over (see dotted figure).
Phillips Screwdriver
Slotted Screwdriver
Straight edge or a 3/4 in. board, this
edge must be perfectly straight.
13