Assembly
2. Position base so that edge is offwork
surface.
3. From inside surface,
put carriage
bolt
through
slot in base and hold in place at
highest point.
4. Slide side frame into place on base so
that table clamp screw mount fits into
notch on side frame.
5. On end of bolt put fiat washer, then
lock washer, then nut and finger tighten.
Note: Later in assembly, these will be
wrench tightened.
6. Repeat for other slot of base.
7. Repeat for other side frame.
Notch
Table Clamp
Screw Mount
8. Set out:
-front stiffener
-four truss head bolts _/16"diameter
bye"
-four sh6" diameter
flat washers
-four 5/16"diameter
lock washers
-four s'16"diameter
nuts.
9. Place front stiffener between side
frames so that tabs of stiffener stay on
inside of side frames.
10. Put bolt through
hole in front stif-
fener tab and through
side frame.
11. On end of bolt put flat washer,
then
lock washer,
then nut and wrench
tighten.
12. Repeat for other 3 holes.
5116" x 518"
Truss Head Bolt
5116" Hex Nut
5/16"
_
_
)
]
Lock Washer
Side Frame
5/16"
Flat Washer
Front Stiffener
15